#the100DayProject Weeks 8 and 9

Handspun yarn wound on a swift with a graphic that says “Spindle Spinning for #the100DayProject Weeks 8 and 9”.

I’ve joined up with #the100DayProject this year with the goal of spinning every day. Writing down a daily log of my progress is an easy way for me to stay accountable, follow though, and plan what to spin next during this project.

If you’re just joining me:
Here’s how I prepped for the project and spent the first week.
During weeks 2 and 3 I finished the first single and started spinning the second.
Weeks 4 and 5 I embraced the slog of being in the middle of something.
Weeks 6 and 7 I finished spinning the singles and started plying.


Handspun yarn being wound onto a swift from a spindle.

Week 8

May 26 (Day 50): Today was the day, the yarn came off the spindle! Looks good too.

I set up my swift and put the spindle in a big bowl to roll around in while I skeined the yarn. Didn’t work as well as I wanted it too though. One, the bowl wasn’t heavy so it fell over a lot and spindle made a break for freedom under the table. Two, my spinning buddy requisitioned the bowl to fill up with rubber salad. Oh well. I ended up pulling off lengths of yarn and winding it onto the swift one section at a time. Finicky? Yes, but doable. I’ll rig up a more reliable solution for next time.

A hand holding a skein of handspun yarn.

Now for the details. I skeined the yarn at a circumference of 72” and got 247 wraps. So, I have a very rough estimate of 494 yards, that’s about 452 m. It ranges in diameter from a fingering weight to sport to worsted. I’m sure that measurements will change after washing, but it’ll be enough to make my spinning buddy something cute to wear this winter.

May 27 (Day 51): While I had my swift set up, I skeined up yarn I had sitting on the bobbin from 2018! The yarn snapped in the middle so I ended up with 2 skeins totaling about 224 yards of worsted/aran weight yarn. We’ll see how it changes after soaking the twist. My spinning buddy really loved this yarn. I’m probably going to set it aside to make something fun for her. A new hat and mitts?

Superwash wool roving on a table to show of its speckled colors.

At the beginning on this project, I picked out 2 bumps of hand dyed fiber. The one I saved for later was dark and muted. Pretty, but not what I’m in the mood to spin now. So, I went digging through the stash and found a fun speckle dyed bump of from Hummingbird Moon. Spinning her fiber always seems like magic which is just what I want right now. There’s no discernible repeat, so I split the length of fiber in half for a 2-ply yarn. Then I split each piece into thirds along it’s length because that’s the fiber wanted to do. I’m still very much at the beginning of this new spin, but the fiber is a pleasure to work with.

The speckled roving divided into 6 nests waiting to be spun into yarn.

May 28 (Day 52): The new fiber I’m working with is definitely taking some adjustment. The color is wonderful, the feel silky, and the wool superwash. I haven’t spun much superwash wool and it’s taking some adjustment. The fibers just don’t hold onto each other like a non-superwash wool does which means my spindle is dropping way more. I need way, way more twist.

Hmm. I was attempting to spin this fiber into a fingering or sport weight yarn, but a worsted weight might be a more achievable goal with this fiber and spindle combo. Maybe I can try spinning a fingering weight superwash on my wheel later.

May 29 (Day 53): It was long day and I didn’t get to my spindle until after my spinning buddy had gone to bed. I spent several aggravating minutes with a single that kept falling apart every time I tried to wind more yarn onto the spindle. I’d fix the break, spin more yarn, try to wind it up, and it would break all over again. After the fifth time everything fell apart, I called it quits for the night.

May 30 (Day 54): Had better luck spinning this morning than I did last night. I’m sure some of it had to do with getting a few hours of sleep, but here’s what else I switched up. One, I’m very definitely making sure that I’m twisting the spindle counter-clockwise. A week’s worth of plying clockwise was apparently enough to reset my fingers and now I need to do it again. Two, I’m aiming to make a thicker yarn than my default. The goal is a worsted weight 2-ply and I’m seeing some success already. Three, I’m spinning shorter lengths before winding the single onto the spindle. By keeping things short I can catch the spindle before it starts slowing down or hitting the ground.

May 31 (Day 55):
I seem to finally be finding my groove with this fiber. The yarn turtle is growing and the spindle is dropping much less.

June 1 (Day 56): Finished spinning the first section of fiber today which means I am a third of the way finished with this first single. Feels like this spin might be moving a little faster than the first.

Week 9

June 2 (Day 57): Managed to spin a decent bit this morning and a little in the afternoon. My spinning buddy still thinks it’s really fun to poke the spindle and make it stop moving. Silly kiddo.

June 3 (Day 58):
Got in a lot of spinning time this morning which was great. I finished spinning the second section of fiber and joined the third and last piece needed for this ply!

A finished handspun single on a spindle sitting in front of the rest of the fiber.

June 4 (Day 59): I wasn’t planning on finishing the first single today, but I did! This yarn is definitely on the lumpy and bumpy side of things and that’s okay. I don’t have much experience spinning superwash fiber so I’m just happy to have figured out enough to make something that holds together.

The color of this yarn is wonderful. There’s some barber-polling in spots, but the speckles and flecks of color have generally combined into a flowing spectrum. The wound up turtle on the spindle reminds me so much of a watercolor.

It is taking all my self control not to pop the spindle apart right now and get started on the next single. Having to put the spindle in the freezer again to take it apart definitely slowed me down a little.

The bottom of the spindle and yarn turtle with the leader tail sticking out.

June 5 (Day 60): Started the second ply today! The first order of business was tying a new leader with a long tail. The long tail is important because it’s easier to keep out of the way while wrapping the spindle and easier to grab when searching for the hidden end of the single.

June 6 (Day 61): I’m more used to spinning superwash wool now than I was a week ago, so my fingers are trying to spin a fine yarn which is not the plan for this handspun. Making myself spin this single for a worsted weight 2-ply.

June 7 (Day 62): Only got a little bit of spinning done this morning before getting out of the house. All my afternoon plans went out the window when I hurt my back bending over to pick up a toy. I’m too young for this.

June 8 (Day 63): Spinning continues today so long as I’m standing or sitting up straight. Slouching is a no go. With that in mind, I’ve made decent progress. The first piece of fiber for the second ply is spun and the second joined. It’s looking good.

An in-progress single on the spindle sitting next to a finished single and more fiber.